| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
can: bcm: add missing device refcount for CAN filter removal
sashiko-bot remarked a problem with a concurrent device unregistration
in isotp.c which also is present in the bcm.c code. A former fix for raw.c
commit c275a176e4b6 ("can: raw: add missing refcount for memory leak fix")
introduced a netdevice_tracker which solves the issue for bcm.c too.
bcm_release(), bcm_delete_rx_op() and bcm_notifier() relied on
dev_get_by_index(ifindex) to re-find the device for an rx_op before
unregistering its filter. If a concurrent NETDEV_UNREGISTER has already
unlisted the device from the ifindex table, that lookup fails and
can_rx_unregister() is silently skipped, leaving a stale CAN filter
pointing at the soon-to-be-freed bcm_op/socket.
Hold a netdev_hold()/netdev_put() tracked reference on op->rx_reg_dev
from the moment the rx filter is registered in bcm_rx_setup() until it
is unregistered in bcm_rx_unreg(), and use that reference directly in
bcm_release() and bcm_delete_rx_op() instead of re-looking the device
up by ifindex. |
| In the Linux kernel, the following vulnerability has been resolved:
cpu: hotplug: Bound hotplug states sysfs output
states_show() adds CPU hotplug state names into a single sysfs buffer
using sprintf(). With enough registered states, this can write past the
end of the PAGE_SIZE buffer.
Use sysfs_emit_at() so output is bounded. |
| In the Linux kernel, the following vulnerability has been resolved:
macsec: don't read an unset MAC header in macsec_encrypt()
macsec_encrypt() reads the Ethernet header via eth_hdr(skb)
(skb->head + skb->mac_header) to memmove() the 12 source/destination MAC
bytes forward and make room for the SecTAG.
On the AF_PACKET SOCK_RAW + PACKET_QDISC_BYPASS transmit path the skb
reaches the macsec ndo_start_xmit() with the MAC header unset, so
eth_hdr(skb) resolves to skb->head + (u16)~0 and the read is out of
bounds: a 12-byte heap over-read that is also emitted on the wire as the
frame's outer source/destination MAC. KASAN reports a slab-out-of-bounds
read in macsec_start_xmit() on 6.0; on current mainline a CONFIG_DEBUG_NET
build flags it as an unset mac header in skb_mac_header().
On the TX path the L2 header is at skb->data, so use skb_eth_hdr(), added
by commit 96cc4b69581d ("macvlan: do not assume mac_header is set in
macvlan_broadcast()") for exactly this purpose. |
| In the Linux kernel, the following vulnerability has been resolved:
s390/zcrypt: Validate length for CCA AES cipher key requests
cca_cipher2protkey() derives the copy length for the CPRB parameter
block directly from the length field in the key token. Reject the
request early if the token length exceeds the available space in the
parameter block. |
| IBM i 7.6, 7.5, 7.4, and 7.3 could allow a remote attacker to obtain sensitive information due to a byte-count and element-count confusion. |
| In the Linux kernel, the following vulnerability has been resolved:
s390/zcrypt: Validate length for CCA ECC private key requests
cca_ecc2protkey() derives the copy length for the CPRB parameter
block directly from the length field in the key token. Reject the
request early if the token length exceeds the available space in the
parameter block. |
| In the Linux kernel, the following vulnerability has been resolved:
btrfs: free mapping node on duplicate reloc root insert
__add_reloc_root() allocates a mapping_node before inserting it into
rc->reloc_root_tree. If rb_simple_insert() finds an existing entry, it
returns the existing rb_node and leaves the newly allocated node unlinked.
The error path then returns -EEXIST without freeing the new node. Since
the node was never inserted into reloc_root_tree, the later cleanup in
put_reloc_control() cannot find it either.
Free the newly allocated node before returning -EEXIST.
The callers currently assert that -EEXIST should not happen, so this is a
defensive cleanup for an unexpected duplicate insert path. If the path is
ever reached, the local allocation should still be released. |
| In the Linux kernel, the following vulnerability has been resolved:
ata: sata_dwc_460ex: fix infinite loop in NCQ tag completion bit-scanning
The hand-rolled bit-scanning loop in the NCQ completion path has an
infinite loop bug. When tag_mask has only high bits set (e.g.
0x80000000), the inner while loop left-shifts tag_mask until it
overflows to 0. At that point !(0 & 1) is always true and 0 <<= 1
stays 0, causing an infinite loop in hardirq context with a spinlock
held.
Replace the open-coded bit-scanning with __ffs() which correctly
finds the least significant set bit and is bounded by the width of
the argument. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/vmwgfx: Validate vmw_surface_metadata::array_size
This field comes from userspace and should be validated against specific
limits depending on which Shader Model (SM) is available. |
| IBM i 7.6, 7.5, 7.4, and 7.3 could allow a remote attacker to cause a denial of service due to an off-by-one error in bounds checking. |
| In the Linux kernel, the following vulnerability has been resolved:
firmware: arm_ffa: Fix NULL dereference in ffa_partition_info_get()
ffa_partition_info_get() passes uuid_str directly to uuid_parse()
without a NULL check. When a caller passes NULL, uuid_parse() ->
__uuid_parse() -> uuid_is_valid() dereferences the pointer, causing
a kernel panic:
| Unable to handle kernel NULL pointer dereference at virtual address
| 0000000000000040
| pc : uuid_parse+0x40/0xac
| lr : ffa_partition_info_get+0x1c/0x94 [arm_ffa]
Add a NULL guard before uuid_parse() so a NULL argument returns
-ENODEV instead of crashing. Callers are expected to always supply
a valid partition UUID, so NULL is not a supported input. |
| In the Linux kernel, the following vulnerability has been resolved:
serial: 8250_mid: Fix NULL function pointer dereference on DNV/ICX-D/SNR platforms
Commit b1b4efea05a5 ("serial: 8250_mid: Disable DMA for selected
platforms") replaced the dnv_board setup and exit callbacks with
PTR_IF(false, ...), which evaluates to NULL. However, the three call
sites in mid8250_probe() and mid8250_remove() unconditionally
dereference these function pointers without NULL checks, causing a NULL
pointer dereference (kernel oops) on any Denverton (DNV), Ice Lake Xeon
D (ICX-D/CDF), or Snowridge (SNR) platform.
Fix this by adding the missing NULL checks before calling the setup and
exit callbacks. |
| In the Linux kernel, the following vulnerability has been resolved:
libceph: bound get_version reply decode to front len
handle_get_version_reply() uses msg->front_alloc_len as the decode
boundary for MON_GET_VERSION_REPLY. That is the size of the reused
reply buffer, not the number of bytes actually received.
A truncated reply can therefore pass ceph_decode_need() and decode the
second u64 from stale tail bytes left in the buffer by an earlier
message, causing an uninitialized memory read.
Use msg->front.iov_len as the receive-side decode boundary, matching
other libceph reply handlers and limiting decoding to the bytes that
were actually read from the wire. |
| IBM i 7.6, 7.5, 7.4, and 7.3 could allow a remote attacker to cause a denial of service due to an out-of-bounds write. |
| In the Linux kernel, the following vulnerability has been resolved:
vxlan: require CAP_NET_ADMIN in the device netns for changelink
A tunnel changelink() operates on at most two netns, dev_net(dev) and
the sticky underlay netns vxlan->net. They differ once the device is
created in or moved to a netns other than the one the request runs in.
The rtnl changelink path checks CAP_NET_ADMIN only against dev_net(dev),
so a caller privileged there but not in vxlan->net can rewrite a vxlan
device whose underlay lives in vxlan->net.
vxlan_changelink() validates and applies the new configuration against
vxlan->net (vxlan_config_validate(vxlan->net, ...)) and can reopen the
underlay socket in that netns, so the same reasoning as the tunnel
changelink series applies here.
Gate vxlan_changelink() with rtnl_dev_link_net_capable(), at the top of
the op before any attribute is parsed, matching ipgre_changelink() and
the rest of the "require CAP_NET_ADMIN in the device netns for
changelink" series.
Found by 0sec automated security-research tooling (https://0sec.ai). |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu/gfx8: drop unecessary BUG_ON()
There's no need to crash the kernel for this case.
(cherry picked from commit 4d7c25208ca612b754f3bf39e9f16e725b828891) |
| In the Linux kernel, the following vulnerability has been resolved:
KVM: x86/mmu: Fix use-after-free on vendor module reload
mmu_destroy_caches() destroys pte_list_desc_cache and
mmu_page_header_cache, but leaves both pointers unchanged. The pointers
live in kvm.ko, and therefore survive when a vendor module is unloaded
while kvm.ko remains loaded.
If creation of pte_list_desc_cache fails during a subsequent vendor
module load, its assignment sets pte_list_desc_cache to NULL and the
error path calls mmu_destroy_caches(). mmu_page_header_cache still
points to the cache destroyed during the preceding vendor module
unload. Passing that stale pointer to kmem_cache_destroy() causes a
slab use-after-free.
Reproduce the issue on a v7.1.3 kernel with CONFIG_KASAN=y,
CONFIG_KASAN_GENERIC=y, CONFIG_KVM=m, and CONFIG_KVM_INTEL=m. A
one-shot test hook forces pte_list_desc_cache to NULL on the second
invocation of kvm_mmu_vendor_module_init():
1. Load kvm.ko and kvm-intel.ko, creating both caches.
2. Unload only kvm_intel, leaving kvm.ko loaded.
3. Reload kvm_intel and force initialization through the -ENOMEM path.
KASAN reports:
BUG: KASAN: slab-use-after-free in
kvm_mmu_vendor_module_init+0x5b/0x170 [kvm]
...
kmem_cache_destroy+0x21/0x1d0
kvm_mmu_vendor_module_init+0x5b/0x170 [kvm]
...
Allocated by task 16817:
__kmem_cache_create_args+0x12c/0x3b0
__kmem_cache_create.constprop.0+0xb6/0xf0 [kvm]
kvm_mmu_vendor_module_init+0x13b/0x170 [kvm]
...
Freed by task 16820:
kmem_cache_destroy+0x117/0x1d0
kvm_mmu_vendor_module_exit+0x21/0x30 [kvm]
Clear both pointers immediately after destroying their caches so that
the stored state reflects the caches' lifetime and repeated cleanup is
safe.
With the fix applied, the same injected vendor module reload fails with
-ENOMEM as expected and produces no KASAN report. |
| In the Linux kernel, the following vulnerability has been resolved:
gpu: host1x: Fix use-after-free in host1x_bo_clear_cached_mappings
__host1x_bo_unpin() drops the last reference to the mapping and frees
it, so we can't dereference mapping afterwards. The cache itself
outlives the mapping, so use the cache local variable instead. |
| In the Linux kernel, the following vulnerability has been resolved:
IB/mad: Drop unmatched RMPP responses before reassembly
Kernel-handled RMPP receive processing starts reassembly for active
DATA responses before the response is matched to an outstanding send.
The normal match happens later, after ib_process_rmpp_recv_wc() has
either assembled a complete message or consumed the segment.
That ordering lets an unsolicited response that routes to a kernel
RMPP agent by the high TID bits allocate or extend RMPP receive state
before the full TID and source address are checked against a real
request. A reordered burst can therefore reach the receive-side
insertion path even though the response would not match any send.
For kernel-handled RMPP DATA responses, require the existing
ib_find_send_mad() match before entering RMPP reassembly. The matcher
already checks the full TID, management class and source address/GID
against the agent wait, backlog and in-flight send lists. If there is
no match, drop the response without creating RMPP state.
This leaves the RMPP window behavior unchanged and only rejects
responses that have no corresponding request. |
| In the Linux kernel, the following vulnerability has been resolved:
btrfs: fix root leak if its reloc root is unexpected in merge_reloc_roots()
If we have an unexpected reloc_root for our root, we jump to the out label
but never drop the reference we obtained for root, resulting in a leak.
Add a missing btrfs_put_root() call. |
