| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A flaw has been found in davenardella snap7 up to 1.4.3. This affects the function TS7Worker::PerformFunctionRead of the file src/core/s7_server.cpp of the component ReadVar Request Handler. This manipulation causes out-of-bounds write. The attack requires access to the local network. The exploit has been published and may be used. The project was informed of the problem early through an issue report but has not responded yet. |
| A potential out-of-bounds write vulnerability could allow a local privileged attacker to modify power management settings in System Management Mode. |
| In the Linux kernel, the following vulnerability has been resolved:
fs/statmount: fix slab out-of-bounds write in statmount_mnt_idmap
statmount_mnt_idmap() writes one mapping with seq_printf() and then
manually advances seq->count to include the NUL separator.
If seq_printf() overflows, seq_set_overflow() sets seq->count to
seq->size. The manual seq->count++ changes this to seq->size + 1.
seq_has_overflowed() then no longer detects the overflow. The corrupted
count returns to statmount_string(), which later executes:
seq->buf[seq->count++] = '\0';
This causes a 1-byte NULL out-of-bounds write on the dynamically
allocated seq buffer.
Fix this by checking for overflow immediately after seq_printf(). |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/siw: bound Read Response placement to the RREAD length
In drivers/infiniband/sw/siw/siw_qp_rx.c, siw_proc_rresp() places each
inbound Read Response DDP segment at sge->laddr + wqe->processed and then
accumulates wqe->processed, but it never checks the running total against
the sink buffer length on continuation segments. siw_check_sge() resolves
and validates the sink memory only on the first fragment (the if (!*mem)
branch), and siw_rresp_check_ntoh() compares the cumulative length against
wqe->bytes only on the final segment (the !frx->more_ddp_segs guard).
A connected siw peer that answers an outstanding RREAD with Read Response
segments that keep the DDP Last flag clear, carrying more total payload
than the RREAD requested, drives wqe->processed past the validated sink
buffer; the next siw_rx_data() call writes out of bounds at
sge->laddr + wqe->processed. siw runs iWARP over ordinary routable TCP,
so the peer is the remote end of an established RDMA connection and needs
no local privilege.
Bound every segment before placement, exactly as siw_proc_send() and
siw_proc_write() already do for their tagged and untagged paths, and
terminate the connection with a base-or-bounds DDP error when the
Read Response would overrun the sink buffer.
This is the second receive-path length fix for this file. A separate
change rejects an MPA FPDU length that underflows the per-fragment
remainder in the header decode; that guard does not cover this case,
because here each individual segment length is self-consistent and only
the accumulated placement offset overruns the buffer. |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: qat - validate RSA CRT component lengths
The generic RSA key parser (rsa_helper.c) bounds each CRT component (p,
q, dp, dq, qinv) by the modulus size n_sz, but qat_rsa_setkey_crt()
allocates half-size DMA buffers (key_sz / 2) and right-aligns each
component with:
memcpy(dst + half_key_sz - len, src, len)
When a CRT component is larger than half_key_sz the subtraction
underflows and memcpy writes past the DMA buffer, causing memory
corruption.
Add a len > half_key_sz check next to the existing !len check for each
of the five CRT components so the driver falls back to the non-CRT path
instead of writing out of bounds. |
| In the Linux kernel, the following vulnerability has been resolved:
USB: serial: keyspan_pda: fix information leak
The write() callback is supposed to return the number of characters
accepted or a negative errno. Since the addition of write fifo support
the keyspan_pda implementation will however return the number characters
submitted to the device if the write urb is not already in use. If this
number is larger than the number of characters passed to write(), the
line discipline continues writing data from beyond the tty write buffer.
Fix the information leak by making sure that keyspan_pda_write_start()
returns zero on success as intended. |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: Validate BTF repeated field counts before expansion
btf_parse_struct_metas() walks user-supplied BTF during BPF_BTF_LOAD,
and btf_repeat_fields() expands repeatable fields from array elements
into the fixed BTF_FIELDS_MAX scratch array used by btf_parse_fields().
The remaining-capacity check performs the expanded field count calculation
in u32. A malformed BTF can wrap that calculation, causing the check to
pass even when the expanded field count exceeds the scratch array
capacity. The following memcpy() can then write past the end of the
array.
Use checked addition and multiplication before copying repeated fields
and reject impossible counts. |
| In the Linux kernel, the following vulnerability has been resolved:
HID: wacom: fix slab-out-of-bounds write in wacom_wac_queue_insert
wacom_wac_queue_insert() calls kfifo_skip() in a loop when the kfifo
doesn't have enough space for the incoming report. If the kfifo is
empty, kfifo_skip() reads stale data left in the kmalloc'd buffer
via __kfifo_peek_n() and interprets it as a record length, advancing
fifo->out by that garbage value. This corrupts the internal kfifo
state, causing kfifo_unused() to return a value much larger than the
actual buffer size, which bypasses __kfifo_in_r()'s guard:
if (len + recsize > kfifo_unused(fifo))
return 0;
kfifo_copy_in() then performs an out-of-bounds memcpy, writing up to
3842 bytes past the 256-byte buffer.
Add a !kfifo_is_empty() condition to the while loop so kfifo_skip()
is never called on an empty fifo, and check the return value of
kfifo_in() to reject reports that are too large for the fifo. |
| In the Linux kernel, the following vulnerability has been resolved:
PCI/IOV: Skip VF Resizable BAR restore on read error
sriov_restore_vf_rebar_state() uses the VF Resizable BAR Control register
to decide how many VF BARs to restore (nbars) and which VF BAR each
iteration addresses (bar_idx). bar_idx indexes into dev->sriov->barsz[],
which has only PCI_SRIOV_NUM_BARS (6) entries.
When a device does not respond, config reads typically return
PCI_ERROR_RESPONSE (~0). Both fields are 3 bits wide, so nbars and bar_idx
both evaluate to 7. The barsz[] access then goes out of bounds. UBSAN
reports this as:
UBSAN: array-index-out-of-bounds in drivers/pci/iov.c:948:51 index 7 is out of range for type 'resource_size_t [6]'
Observed on an NVIDIA RTX PRO 1000 GPU (GB207GLM) that stopped responding
during a failed GC6 power state exit. The subsequent pci_restore_state()
invoked sriov_restore_vf_rebar_state() while config reads returned
0xffffffff, triggering the splat.
Bail out if any VF Resizable BAR Control read returns PCI_ERROR_RESPONSE.
No further VF BARs are touched, which is safe because a config read that
returns PCI_ERROR_RESPONSE indicates the device is unreachable and
restoration is pointless. This mirrors the guard in
pci_restore_rebar_state(). |
| In the Linux kernel, the following vulnerability has been resolved:
iio: adc: ad_sigma_delta: fix clear_pending_event for registerless devices
ad_sigma_delta_clear_pending_event() falls through to the status register
read path for devices with has_registers = false and no rdy_gpiod. For
such devices, ad_sd_read_reg() skips the address byte entirely and clocks
raw MISO bytes with no address phase — making it byte-for-byte identical
to reading conversion data. If a pending conversion result is present,
this partially consumes it and corrupts the data stream for the subsequent
ad_sd_read_reg() call in ad_sigma_delta_single_conversion().
Furthermore, with num_resetclks = 0 on these devices, data_read_len
evaluates to 0. If the clocked byte has bit 7 clear, pending_event is set
and the code attempts memset(data + 2, 0xff, 0 - 1), overflowing to
SIZE_MAX and corrupting the heap.
Fix by returning 0 immediately when neither rdy_gpiod nor has_registers
is set. This is safe for all current registerless devices: ad7191 and
ad7780 (with powerdown GPIO) are reset between conversions by CS
deassertion, so there is no stale result to drain; ad7780 (without
powerdown GPIO) and max11205 are continuously-converting and cycle ~DRDY
at the output data rate regardless of whether the previous result was
read, so the next falling edge fires naturally.
A future registerless device that holds ~DRDY asserted until data is read
would be broken by this early return and would require either
num_resetclks set or a rdy-gpio.
The same heap corruption is reachable on any device with rdy_gpiod set
but num_resetclks = 0: if the GPIO indicates a pending event, the drain
path executes memset(data + 2, 0xff, 0 - 1) regardless of has_registers.
Add an explicit data_read_len == 0 guard after the pending event check;
the stale result is then consumed by the first ad_sd_read_reg() call in
ad_sigma_delta_single_conversion(). |
| In the Linux kernel, the following vulnerability has been resolved:
firmware: arm_ffa: Bound PARTITION_INFO_GET_REGS copies
The register-based PARTITION_INFO_GET path trusted the firmware-provided
indices when copying partition descriptors into the caller buffer.
Reject inconsistent counts or index progressions so the copy loop cannot
write past the allocated array.
(fixed cur_idx when exactly one descriptor in the first fragment) |
| Out of bounds write in ANGLE in Google Chrome prior to 151.0.7922.72 allowed a remote attacker who had compromised the renderer process to potentially perform a sandbox escape via a crafted HTML page. (Chromium security severity: High) |
| Heap buffer overflow in Color in Google Chrome on ChromeOS prior to 151.0.7922.72 allowed a remote attacker who had compromised the renderer process to potentially perform a sandbox escape via a crafted HTML page. (Chromium security severity: High) |
| Out of bounds write in WebGL in Google Chrome on Android prior to 151.0.7922.72 allowed a remote attacker to potentially perform a sandbox escape via a crafted HTML page. (Chromium security severity: High) |
| Out of bounds read and write in Tint in Google Chrome prior to 150.0.7871.46 allowed a remote attacker to potentially perform out of bounds memory access via a crafted HTML page. (Chromium security severity: High) |
| Out of bounds write in ANGLE in Google Chrome on Mac prior to 150.0.7871.46 allowed a remote attacker to potentially perform a sandbox escape via a crafted HTML page. (Chromium security severity: Medium) |
| Insufficient validation of untrusted input in Variations in Google Chrome prior to 151.0.7922.72 allowed an attacker in a privileged network position to potentially exploit heap corruption via malicious network traffic. (Chromium security severity: Medium) |
| A potential out of bounds write vulnerability could allow a local privileged attacker to execute code in System Management Mode. |
| CVE-2026-40953 is a heap overflow in the
certificate parsing function of Secure Access clients prior to 14.55. Attackers
with local access and administrator permissions can create a denial of service
attack against the client over which they have control. |
| ncnn is a high-performance neural network inference framework optimized for the mobile platform. In commit e54f7b1f88434e1d844ea0551b880a1cfb079ce1 and earlier, ncnn allows an out-of-bounds heap write in ncnn::ParamDict::load_param() when Net::load_param() loads a malicious .param model file because the parsed parameter id is checked only against id >= NCNN_MAX_PARAM_COUNT, allowing a negative id to index before the params[NCNN_MAX_PARAM_COUNT] array. This vulnerability is fixed by commit 5a0288f255daa6c3294f77109f67718e434ec020. |
